Industrial Air Technologies.
Maximum safety, high efficiency and sustainable treatment in demanding process conditions.
Industrial air technology and
solutions for corrosive processes
We design turnkey air treatment and ventilation systems for industrial processes that release corrosive and toxic gases. In chemicals, plating and wastewater treatment we deliver long-life engineering that meets international standards and lowers operating cost.
We go beyond supplying standard products and develop systems matched to the chemical load and capacity of your process. With European-standard layout optimisation and process improvement experience, we make sure each system is integrated into your plant correctly — mechanically and in terms of fluid dynamics. The goal is environmental compliance with the lowest possible energy consumption.
Below are the four product groups that manage the corrosive gas and emission load of your plant:
These neutralise toxic, corrosive or odorous gases with a high efficiency before they reach the atmosphere. Each is sized specifically for the capacity and chemistry of the process; our engineering calculations target 99 % removal. Meet our packed bed, cross-flow, fume, venturi and dry scrubbers, and our degasser towers.
Gas Scrubbers
02
By separating liquid droplets and fine mist from the air or gas stream through physical impaction, these extend the life of fans and ducts and improve emission quality. With our droplet and mist eliminators, wet baffle units and compact cyclone separators you remove the liquid load from your process air at source.
Droplet and Mist Eliminators
03
Our fan ranges are built for acidic and corrosive ventilation duties that metal fans cannot survive, with high aerodynamic efficiency. PP, HDPE, flame-retardant PPs and ATEX / Ex-Proof ranges keep ventilation running even in explosive and flammable atmospheres.
Industrial Plastic Fans
04
The air transport lines are the lifeline of the system, and we design and install them with full protection against corrosion. Plastic air ducts, stacks and jet-cap designs, acid canopies, dampers and butterfly valves in PP, PPs, HDPE or PVDF — chosen for your process — give outstanding corrosion resistance.
Ventilation Equipment
99 % removal efficiency
Maximum emission control in scrubbers sized by advanced engineering calculation.
Full compliance
Strict conformity with environmental legislation and occupational health and safety standards.
ATEX & CE standards
Ex-Proof plastic fans and ventilation equipment for explosive and flammable atmospheres.
A broad material range
Outstanding corrosion resistance through PP, PPs, HDPE and PVDF selected for your process.
Frequently asked questions
It depends on the thermoplastic chosen. Polypropylene (PP) and polyethylene (HDPE) generally run without difficulty between 60 and 80 °C, while special PPs or PVDF versions can be designed for higher temperatures and harsher chemicals.
Yes. For plants with chemical vapours and explosion risk (Zone 1 / Zone 2) in particular, we supply Ex-Proof plastic fans conforming to the ATEX directives and ventilation equipment built to international standards.
Certainly. Before installation we calculate your layout, process flow rate, emission limits and pressure losses in detail, and our engineers design the most suitable system architecture from those figures.